ZERO VOLT MONITOR

• Dual Station Continuous Monitor for 2 Operators And 2 Worksurfaces
  Continuously monitors the path-to-ground integrity of two operators and two ESD worksurfaces independently
• Zero Volt Monitor Technology
  Places dual test signals onto each of the dual-wire wrist strap’s conductors to negate finger-tip voltage and the risk of electrical overstress (EOS) for the handling of sensitive components
• Operator Charge Detection
  Alarms should voltage greater than ±1.25 V become induced onto the operator
• <500 Millisecond Alarm Response Time
  Identifies failures and intermittencies that inferior technologies miss
• Adjustable Worksurface Test Limits
  Configures the monitor to be paired with multiple types of worksurface materials
• Replaceable Operator Remote Kits with 3.5 Mono Jacks and Auxiliary Banana Jacks
  Replaces the black and white operator remotes should their jacks become worn
• Compatibility with Dual-Wire Wrist Straps
  Meets ANSI/ESD S20.20 in accordance with ESD TR1.0-01-0
• Calibration Verification
  Use the Desco 50524 Dual-Wire Monitor Limit Comparator to check the test limits of Zero Volt Monitors without removing them from their workstations
• NIST Calibrated with Certificate Included
  Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology. For more information on the calibration of Desco products, see Calibration.
• 100-240VAC Power Adapter with North American Plug
  Works with standard electrical systems in North America, United Kingdom, Japan, Asia and Europe
• Made in the United States of America
  This item is made and stocked in Chino, CA

*The ESDA Wrist Strap standard is ANSI/ESD S1.1. The Wrist Strap System required limit per ANSI/ESD S20.20 Table 3 is 0.8 to 1.2 x 10⁶ ohms with product qualification testing per ANSI/ESD S1.1. The test range of the monitored circuit is 500 kilohms to 10 megohms.