- Dual Operator Workstation Continuous Monitor
Continuously monitors the path-to-ground integrity of two operators and one ESD worksurface
- Wave Distortion Technology
Provides stable continuous monitoring (versus pulsed or intermittent) of the wrist strap’s path-to-ground* and the presence of its 1 megohm safety resistor
- IMPROVED Operator Alarm
Alarms when the operator unintentionally disconnects from the monitor or the connection between the banana plug and monitor’s jack is intermittent
- NEW Park Delay Timer
Indicates the 8 second delay to disconnect and park the operator wrist cord
- NEW Visual Status Display
Displays the operators’ and worksurface status: illuminates red when intermittent or failed connection occurs
- NEW Mat Monitor Switch
Disables the worksurface monitor circuit when used in areas where there is no ESD worksurface
- NEW Audible Alarm Adjustment
Sets the audible alarm volume from loud to louder
- NEW Power Relay Accessory
Controls power to workbenches, hand tools, and other electronic devices dependent on the Dual Operator Continuous Monitor’s status
- Wave Distortion Technology
Provides stable continuous monitoring (versus pulsed or intermittent) of the wrist strap’s path-to-ground* and the presence of its 1 megohm safety resistor
- Park Snap
Allows the operator to disconnect (and park) a wrist strap when leaving the workstation without creating a false alarm
- Single-wire Impedance Design
Meets ANSI/ESD S20.20 in accordance with ESD TR1.0-01-0
- 1.2 Volt Operator Test Voltage
Reduces the risk of electrical overstress (EOS) for the handling of sensitive components
- <50 Millisecond Alarm Response Time
Identifies failures and intermittencies
- Calibration Verification
Use the Desco 98221 Wave Distortion Monitor Verification Tester to check the test limits of Wave Distortion Monitors without removing them from their workstations
- NIST Calibrated with Certificate Included
Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology.
- 100-240VAC Safety Certified Power Adapter with North American Plug
Works with standard electrical systems in North America, Japan, and Asia
- Made in the United States of America
This item is made and stocked in Chino, CA
*The ESDA Wrist Strap standard is ANSI/ESD S1.1. The Wrist Strap System required limit per ANSI/ESD S20.20 Table 3 is 0.8 to 1.2 x 106 ohms with product qualification testing per ANSI/ESD S1.1. The test range of the monitored circuit is 500 kilohms to 10 megohms.
