MULTI-MOUNT MONITOR, NORTH AMERICA
- Single Workstation Continuous Monitor
Continuously monitors the path-to-ground integrity of one operator and one ESD worksurface
- IMPROVED Operator Alarm
Alarms when the operator unintentionally disconnects from the monitor or the connection between the banana plug and monitor’s jack is intermittent
- NEW Mat Monitor Switch
Disables the worksurface monitor circuit when used in areas where there is no ESD worksurface
- NEW Audible Alarm Adjustment
Sets the audible alarm volume from loud to louder
- NEW 19653 Remote Alarm Accessory
Connect to the Multi-Mount Monitor and place in the operator’s field of view to alert operator of alarms
- Desco Wave Distortion Technology
Provides stable continuous monitoring (versus pulsed or intermittent) of the wrist strap’s path-to-ground* and the presence of its 1 megohm safety resistor
- Park Snap
Allows the operator to disconnect (and park) a wrist strap when leaving the workstation without creating a false alarm
- Single-Wire Impedance Design
Meets ANSI/ESD S20.20 in accordance with ESD TR1.0-01-0
- 1.2 Volt Operator Test Voltage
Reduces the risk of electrical overstress (EOS) for the handling of sensitive components
- <50 Millisecond Alarm Response Time
Identifies failures and intermittencies that inferior technologies miss
- Continuous Visual and Audible Alarms
Illuminates green to indicate proper grounding; illuminates red and sounds audible alarm when intermittent or failed connection occurs
- Calibration Verification
Use the Desco 98221 Monitor Calibration Unit to check the test limits of Wave Distortion Monitors without removing them from their workstations
- NIST Calibrated with Certificate Included
Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology.
- 100-240VAC Power Adapter with North American Plug
Works with standard electrical systems in North America, Japan and Asia
- Made in the United States of America
This item is made and stocked in Chino, CA
*The ESDA Wrist Strap standard is ANSI/ESD S1.1. The Wrist Strap System required limit per ANSI/ESD S20.20 Table 3 is 0.8 to 1.2 x 106 ohms with product qualification testing per ANSI/ESD S1.1. The test range of the monitored circuit is 500 kilohms to 10 megohms.